Ender 3 Pro Cable Channel Protective VENT

thingiverse

This protective cover/channel VENT secures cable entry to mainboard on the Ender3 Pro. This will seal off the hole where cables normally go into the control box, designed specifically for individuals who have modified their printer to relocate the control box to the rear, rendering the cable pass through hole useless. Not thoroughly tested yet; work in progress. It should fit though since it was adapted from a proven design. If you need the cable passthrough protector, refer to the original version here: https://www.thingiverse.com/thing:4202535 To install it, an M3 T-nut and M3x10mm screw along with washer are required. This cover was designed for a 25x14.5mm hole, with the channel extending approximately 41mm into it. Note: This part is not oriented for printing. If you need one for the original Ender3 model, check out the other version here (TBD). The STEP file is included for easy remixing.