Ender 3 Pro Cable Channel Protective VENT

prusaprinters

<p>This is a protective cover/channel VENT for the cable entry to the mainboard on the Ender3 Pro.</p> <p><strong>This will block the hole where the cables normally go into the control box, and is designed for people who have done mods to move their control box to the rear of the printer, leaving the cable pass through hole unused. This is not tested and I will leave it in work in progress. It should fit however since it was remixed from a tested design.</strong> If you need the cable passthrough protector, see the thing this was remixed from here:<br/> <a href="https://www.thingiverse.com/thing:4202535">https://www.thingiverse.com/thing:4202535</a><em>**</em></p> <p>To install it, an M3 T-nut and M3x10mm screw and washer will be needed.</p> <p>This was designed for a hole that is 25x14.5mm and the channel extends approximately 41mm into the channel.</p> <p>This part is not oriented for printing.</p> <p>If you need one for the original Ender3, check out the other version here:<br/> (TBD)</p> <p>The STEP file is included for easy remixing.</p> Category: 3D Printer Parts