Ender 3 Pi Camera Mount for Stepper Motor

thingiverse

I printed out a Hero Me Gen2 and the old camera mount that clipped on would stop the x-axis endstop from activating. I created this remix to simply attach the camera to the screws behind the QR code sticker on my Ender 3 printer. To make it work, I had to buy some M3 x 45mm screws from Home Depot for $1.24 since the stock screws were too short. Additionally, I needed two washers on each screw because the new ones were slightly too long. This is a replacement arm, print out the original's camera parts to hold the actual camera board. If you want to enhance your camera setup, consider using an extra stepper motor damper. I updated this remix on March 21st, 2019, with a flipped model that allows for a higher camera position rather than a lower one.