Ender 3 MKS Gen L adaptor case and mount - Remix with Flush Front

thingiverse

Updated Feb 5, 2020: I quickly realized that the fan wouldn't fit into the previous design, so I made a change. Additionally, I lengthened the screw holes by 2mm to ensure my M3-8 screws would fit snugly and securely, and I added extra holes for two of them to house M3 bolts, which will provide better board support since it's hanging upside down and my first print had a problematic screw hole that refused to thread properly. --- Updated: I've made further adjustments: - I enlarged the tab recess area - I introduced a "hollow" version that reduces one of the sides instead of maintaining a solid structure I successfully printed the non-hollow model without supports, and it turned out well despite the overhang for the fan. However, there was some minor stringing involved. I still need to print the "hollow" model, but I believe adding supports will make all the difference in that case. STEP file included! --- This is a remix of the (amazing!) #TeachingTech enclosure for the MKS Gen L. I remixed this project because I wanted a flush front (as opposed to a fan protruding out on its own) and I needed some practice with Fusion360. You shouldn't require supports since the infill will provide adequate support for the top. I'm considering hollowing out the front. I've included the STEP file for Fusion360 if you'd like to give it your own spin! I didn't include the "lower lid" from the original because the original one will work perfectly fine. I'm currently printing this and haven't seen if it actually works yet - this is still a work in progress!