Ender 3 MKS Gen L Adapter Set for Heat Inserts

thingiverse

I didn't like any of the existing mounts, most putting screw heads directly under the MKS Gen L board and then providing thin self-tapping mounts for the mks. This version is designed specifically for use with McMaster M3 3.8mm tall tapered heat inserts. Six total inserts are included (four for the MKS and two for bottom attachment to the housing), three for each piece, allowing for secure mounting from the bottom of the metal housing through the bottom vent holes using M3 screws and wide washers. The MKS Gen L is positioned as close as possible to the front and left side of the housing while still allowing a right-angle USB connector. Also included is a reduced thickness cable protector to give you some extra room, as the MKS Gen L in the stock housing can be quite tight, especially if you're using barrel connectors on your terminals. This should print as three 0.4mm lines; to get this in S3D, use "Allow single extrusion fill" under "Internal Thin Wall Type". Heat Insert Part: www.mcmaster.com/94180A331