Ender 3 Left Side Linear Rail Damper Thing

thingiverse

Ender 3 left side linear rail spacer, bracket arm, and cap for stepper damper installation. I created this solution to enable dampers with a linear rail setup by screwing through the spacer, securing the damper with two M3 screws. For a better understanding, please check out https://www.thingiverse.com/thing:3271077. The installation order is as follows: 1. Stepper-damper 2. Left side bracket 3. Spacer and finally limit switch "cap" The "cap" can be attached in two ways. The first method allows you to screw the spacer directly to the damper, then attach the cap later using alternative holes (the spacers' location accommodates hex cap screw heads I had on hand). The second option is to use included spacers and attach normally if you have long enough screws. I noticed after printing that the "cap roof" is the same width as the spacer. If you really want, edit the "cap" so it can be installed on the opposite side or work around it as intended.