Ender 3 LED Profile w/ KCD1-101 Switch Case

thingiverse

LED Strip Holder for 5050 LED Strips + End-cap. Remix Changes: * Changed the end-cap to house a KCD1-101 toggle switch. Print this piece on its side with supports for the aluminum extrusion bits. The rest should print fine with no supports. * Split the LED profile bar into two pieces that combine together. Print one of each of the male and female versions. These two pieces are designed specifically for the Ender 3 in terms of length, and combined together will span the top beam of the aluminum extrusion perfectly. Print these with a low travel acceleration, print acceleration, and jerk. I used five hundred, two fifty, and eight respectively. May also need quite a large brim. All that said, it will fit on other printers that use 2020 extrusions perfectly, if the top bar is twenty-five centimeters.