Ender 3 Led Light Strip Mount for 3DFused X Gantry

thingiverse

This is a light strip holder that I made for the 3Dfused x gantry. The lights are mounted using the existing holes and screws from the rail. Just line up the holder and remove the stock corresponding screw then screw it back in on the other side with the holder attached. No extra hardware is required to install other than the lights and wires to connect them to the power supply. I just tapped the green 24volt connector on the motherboard for power. The wires will need to be routed through the the stock wire loom connected to the hotend so they can travel up and down the z axis without issue. I used a 24v 8mm wide COB LED light strip off of Amazon. The cut points for the strips should line up with the screw holes on the holder. Any longer and you risk having the lights bind along the z axis. Feel free to test the length that works for you though. I think the only thing I would change is adding a loop of some sort to help guide the wires up and over the gantry so they can can go through the loom a bit easier.