Ender 3 - Filament holder DELUXE Bushing for 5/16"x6" Bolt

thingiverse

This is a simplified version of the Ender 3 Filament Holder DELUXE that requires minimal hardware modifications.\r\n\r\nOriginal Design:\r\nhttps://www.thingiverse.com/thing:3114139/files\r\n\r\nYou will need to acquire the following components:\r\n\r\n1) A single 5/16"x6" bolt\r\n2) One 5/16" Nylock nut\r\n3) Two 1/4" washers (not one, but two)\r\n\r\nInstall the washers inside the bushing first, then insert the bushing into the bearing pockets. The bearings would normally occupy this space. The washers are nearly identical in size to the bolt and should glide smoothly along its length.\r\n\r\nAs a cost-effective alternative to using two bearings, this setup is surprisingly effective. \r\n\r\nWhen installing the fixed flange on one end, face the bushing's flat side outwards and position the washer towards the long threaded rod for optimal results.