Ender 3 Filament Guide Short + Redirect

thingiverse

I'm sorry about the terrible print job; this filament is really giving me a hard time.\r\n\r\nIt's probably because my filament holder wasn't properly aligned, which causes certain spools of filament (like the one I'm using now) to get stuck on subsequent lines in the roll, snagging and ultimately damaging the steppers if I don't keep an eye on it.\r\n\r\nThis should line up the filament coming off the spool more evenly and shift it into place for feeding, preventing those pesky snags from happening.\r\n\r\n**Note:** I printed this without supports and at a breakneck speed (80 was way too fast for the overhangs to cool down in time), so you'll notice some subpar quality here. At some point, I might reprint it with a better slicer profile - I'm sure you'll do a much better job than I did!