Ender 3 Filament Guide Short + Redirect

prusaprinters

<p><i>Forgive the absolutely atrocious print job; this filament hates me.</i></p><p>Presumably due to improper alignment of my filament holder, certain spools of filament (such as the one this is printed with) keep getting caught on later lines in the roll, snagging, and ultimately grinding the steppers if I'm not there to babysit it.</p><p>This should line the filament coming off the spool more centered, but still shift the filament into the correct place for the feed, mitigating these crosses from happening.</p><p><strong>Note:</strong> I printing this without support and at too high of a speed (80 was way too much for the overhands to cool in time), so I have some poor quality going here. At some point I may reprint this with a better slicer profile - I'm sure you'll do better than I did. :)</p><h3>Print Settings</h3><p><strong>Printer Brand: </strong>Creality</p><p><strong>Printer: </strong>Ender 3 Pro</p><p><strong>Rafts: </strong>Doesn't Matter</p><p><strong>Supports:  </strong>Doesn't Matter</p><p><strong>Resolution: </strong>0.2mm</p><p><strong>Infill: </strong>20%</p><p><strong>Filament: </strong>Sunlu PLA Gray </p><p><strong>Notes: </strong>I sliced with (experimental) tree supports on, but apparently Cura decided it didn't need them.</p><p> </p><p>Originally posted at https://www.thingiverse.com/thing:4011577</p>