Ender 3 Filament guide MOUNT only with nut pocket

cults3d

Edit 2-4-2022 I made more mounts and redesigned the pulley halves and retainer. See https://www.thingiverse.com/thing:5232781 So I did a small remix of the MOUNT only. I was having issues with the screws and the material. I like the "nut pockets" in the petsfang bullseye fan project so much I did the same thing with this mount. Now instead of trying to force the screw into the plastic, you push a standard M3 nut in and use an M3x16mm long screw/bolt. I also decreased the diameter where the bearing rides. With my PLA settings it was slightly tight. 20 minutes in the freezer the plastic shrink fits right into the room temp bearing. I also run the material reducing channels thru the part, the 3 legs equal out to a solide section. very strong. Note to using the existing other parts- I printed the retainer at 108% its slightly loose and thats OK. I would advise reading the comments as the pulley halves needed to be upsized as well.