Ender 3 Ender 5 - SeeMeCNC EZStruder Filament Sensor

thingiverse

Here's a tough one, folks! This mount for the Ender 3 or Ender 3 Pro is super tricky due to the tight space between the filament feed opening and the lead screw. But we managed it, and this bracket will do the job nicely. It'll hold the filament runout switch, available from several suppliers - I got mine from Amazon. https://www.amazon.com/XCSOURCE-Printer-Filament-Detection-TE720/dp/B06ZZ5YXM6 I've also spotted the same switch on AliExpress: https://www.aliexpress.com/item/33029742626.html To mount this bracket, you'll need two 3 mm x 25 screws. If you're using an MKS Gen L board on your Ender 3, use SERVO3 (D4) to connect it up - just make sure you get the wiring right, swapping the voltage and ground wires. I've also updated the design to work with the TriangleLab filament runout sensor. You'll need two M3 x 12 screws and two M3 nuts for that one. If you enjoy these designs as much as I do, please consider a Tip for the Designer - I'm on a tight Social Security income, and every little bit helps. Or you can send an Amazon Gift Card to benebrady@gmail.com