Ender 3 & Ender 5 - Reprap Full Discount Smart Controller Display Housing

thingiverse

I wanted to integrate my Reprap Full Graphics Smart Controller seamlessly with my new SKR 1.3 board on my Ender 3, so I designed this housing to make that possible immediately. This solution provides SD card functionality that I lost when switching to the new board. It can also be used in conjunction with the MKS Gen L board. Please consider making a contribution as a Tip for the Designer, since I'm living on a very limited Social Security income and rely on these designs as a source of enjoyment and additional funds for my test prints. You may send an Amazon Gift Card to benebrady@gmail.com if you prefer. Hardware: Two M3 x 20 cap screws should be used for the top two screws, while two M3 x 16 cap screws are required for the bottom two screws. UPDATE: On June 3, 2019, I modified the front panel displays slightly because the more upright angle of the display conflicted with the X carriage as it probed with a BL-Touch. To resolve this issue, I added a 25 mm offset to the right, moving the display out of the way of the X axis. UPDATE: On June 2, 2019, I added the display front for the Ender 5 and Ender 3 printers, including the option of a flat reset button on the front to prevent accidental presses. UPDATE: On June 1, 2019, I added the display front for the Ender 5 printer to use the Reprap Discount Full Graphics Smart Controller display with either the MKS Gen L or SKR 1.3 board.