Ender 3 / Ender 5 / CR-10 - Auto Bed Leveling / Direct Drive Light Weight Mount

thingiverse

This is a complety re-design from Teaching-Tech's hotend system, but it uses the same mount/principle of a flexible part on the right side that activates the limit switch. It uses about half of the amount of plastic from the original design, but it needs lots of m3 bolts (lenght: 12mm), 5 nuts, 3 washers and the original mounting screws. At least, this is the only type of bolt that you need. How to mount it is pretty straight foward, you can use the images and the STEP file as a guide. To configure the software see the original post.