Ender 3 (Ender 3 V2) filament guide for red aluminum extruder

thingiverse

This is one of the best mods I've made on my printer, I'm able to load filament directly into the extruder without having to look/fish around the back side of the printer to do so, in addition to preventing the filament from coming in contact with the Z-screw. Remix of Lucky3310's filament guide Relocated the filament tube so it aligns with my Amazon red aluminum extruder (the one that comes with almost every Ender upgrade kit on Amazon or Aliexpress). Also eliminated the X cable holder, which didn't align properly on my Ender 3 V2. Uses stock hardware, just need a 2"-3" piece of bowden tube It may be necessary to file the holes for the tube a bit to get it to fit. The hole is intentionally just a little undersize so you can get a snug fit. I used a phillips driver in my drill to flare the end of the bowden tube where filament goes in to make it even easier to load.