Ender 3 Display Wedge

thingiverse

I'm not thrilled with the display on my Ender 3, it's almost flat and has a terrible glare making it hard to read unless I hover right over it. To improve the situation, I adjusted the display upwards slightly which makes reading much easier while sitting down. So, I came up with this simple fix. This wedge can be printed and placed between the 4040 and the display bracket. I used two M5-16 mm screws to do the job, moving the display board upward in the process. This solution works with or without the SD tray, and you can use it separately from the wedge as well. If you want to move your display up without bending the metal bracket then this might be just what you need. Also worth noting is that you can adjust the angle of the wedge by tweaking the axis width in Cura for example, allowing you to make a larger or smaller wedge.