Ender 3 Direct Drive - BMG + E3D V6 + BLTouch

cults3d

I was not satisfied with the original solution, so I tried to modify it as follow: BLTouch support in front of the body (I didn't want to block air flow from the side cooler). Duct is closer to the nozzle and flows more accurately. Duct is higher so it doesn't cover view to the nozzle and also doesn't accidentally "touch" paper clip which I use as glass holder. Duct, BLtouch holder, 5015 FAN holder use M3 DIN934 nuts and M3 screws. ####Rev. 3 @16.1.2021 Cable holder added ####Rev. 2 @ 6.1.2021 Few small modification in the source files. BLTouch offset: -27,2mm in X; -31,4 mm in Y. Z axis is up to you (please follow manufacturer instruction). ####Rev. 1 Both body parts are screwed together by two M3x22 DIN912 screws and M3 nuts (see attached picture). Thanks to @Kiron and also @Leovade