Ender 3 Creality Glassbed Holder

thingiverse

I redesigned this part since the original one was intended for a 240x240 glass bed, but mine is only 235x235. The Section for the Heatbed Cable had to be rearranged and resized because there was no way it would fit otherwise. This new version was printed with normal PLA and reinforced with an M4 nut to ensure stability. So far, it's working well at 60C bed temperature, but don't push it too hard as it can get a bit wobbly. If you're using PETG or any other heat-resistant material, this part should perform even better.