Ender 3 Clip On Display Rear Cover (No Screws)

thingiverse

Another Ender 3 cover, designed with inspiration from a few other users' ideas and some tweaks of my own. I opted for snaps that securely lock around the board, eliminating the need for screws. A beeper cap is also included, although I extended it slightly to incorporate a piece of foam at the end, which helps to dampen the sound even further - a feature I borrowed from someone else's design, but unfortunately can't recall exactly who came up with it first. To install this cover, simply push it around the edges until it snaps into place securely. When you're ready to remove it, just bend the corner nearest to the ribbon cable outwards slightly. This will release the corresponding snap, allowing you to get your fingers underneath and gently pry off the rest of the cover.