Ender 3 cable holder v2 (no supports)

thingiverse

This works well with my pets, Fang Bullseye and Cable Chains. Also used with the Hero. The 90-degree angle keeps the wire fairly level and out of the way going out to the hot end. It also keeps the cable chain from leaning outward while the Z-axis is low. It's perfect for the cable chain when the Z-axis is all the way up. I printed it in the same orientation as it would bolt into place, just like how it's pictured here. Printed in fine resolution to show off all corners. It will work at 0.2, but just won't look as nice. Supports are needed for V1. Enjoy! ------------------------------------------------------------------------------------------------------------------------ V2 UPDATE ------------------------------------------------------------------------------------------------------------------------ I've uploaded v2.0. This version is printable without supports! Just print it upside down and you can get away without supports. The part where the cable goes doesn't look as nice, but it's covered up anyway! This version requires very small zip ties (smaller than what came with your printer). It's also lowered, giving you more room to work around the extruder. I've enjoyed making this as my first part for the community, and I hope you enjoy this updated version.