"Ender 3 Cable Chain, no screws, no unplug cable" remix for extruder and hot end

thingiverse

I managed to cobble together a hasty combination of the small cable chain and a different extruder/printhead mount (unfortunately, I couldn't locate it anymore - there are just too many with the exact same design). The extruder mount requires supports. It's positioned well for the bullseye but you have to remove the cable guide from the bullseye itself. No additional screws needed, using the original screw for the extruder and the printhead snaps on. Print time is approximately 30 minutes each. The fitting cable chain STL is included (print at 0.2 or lower for smooth movement). I made a mistake earlier, used the same connector on both ends - it's been fixed now and I've also improved the extruder mount in general.