Ender 3 Bed Spring Stabilizer

thingiverse

Always having to re-level your bed? I don't think the problem is the springs as much as how they were put together. That wiggle room between the X and Y springs ultimately affects the Z, especially when removing prints that are hard to come off. The main reason aftermarket springs are better is because they have a 4mm inside diameter, same size as the screw. This print achieves the same thing in just 15 minutes and about $0.02 of filament. The short one is for the back corner. Try these out before you decide to buy new springs. You'll still have to level your bed periodically, but it should be much less often. These are designed specifically for stock springs and build plates.