Ender 3 Bed Handle with C270 Camera Arm

thingiverse

I found Variour's Camera Arm to be satisfactory, yet I was not pleased with its tendency to swivel freely when bumped. Seeking a solution to secure it in place, I discovered Gordineerpeter's Bed Handle and decided to integrate the two parts seamlessly. To simplify adjusting the vertical angle of the camera for larger prints, I redesigned that section of the arm to feature an adjustable z-screw. Currently, I'm experimenting with making this "spring-loaded" so the camera always rests at its lowest point as set by the screw, which I believe can be achieved with a rubber band tied through the hole below it on the arm. The original part was too large for reliable printing, so I had to divide it into two parts that can be screwed or glued together. The holes are designed to accommodate M3 screws. All parts should print in their respective orientations as indicated in the STL files. Use supports on the hand side of the Bed Handle, but block any supports where it slots onto the Y carriage. The Camera Arm retains the slot from Variour's design for the LED bar, although I chose not to include that part with this redesign.