Ender 3 basic temp tower Polycarbonate

thingiverse

This Print is Best Conducted in Vase Mode ***This Was a Learning Experience Rather Than a Successful Temp Tower Print. The Printing Speeds Used Were Around 15mm/s. At This Slow Pace, Temperatures Above 275c Will Cause the Filament to Cook Off Before It Leaves the Nozzle. It Will Appear as Though Moisture is Present Inside the Tower. This Tower Will Display Fine Quality at 275 Degrees and Excellent Layer Adhesion at >295. The Solution Was Higher Printing Speeds (~50 mm/s) at 300c, Resulting in Good Quality and Adhesive Layers That Were Unseen in This Temp Tower G Code.*** 305c-275c This Test is Designed to Evaluate Pure Layer Adhesion and Flowrate Efficiency. I Prefer Not to Exceed 305c for an Extended Period and Rely on 275c Working Suitably with Gizmodorks PC (Rated 255-300).