Ender 3 Angled Filament Holder

thingiverse

I experienced problems with his holder myself, and I didn't want to have to worry about bending the spool holder or not bending it enough and having the spool fall off while printing - With the original design, I encountered issues with it falling off during a print. In this modified version, I angled the holder approximately 2 degrees and added a stop on the end to help prevent filament roll from falling off. Printed horizontally, then roller printed vertically. A nut was also printed horizontally. If you need to remove the stop, you can simply trim it with scissors. I added a thicker version where the stops are reinforced. I discovered that the original stops were too thin. You will require two 608ZZ bearings.