Ender 3 Adjustable Feet (2") Remix

thingiverse

I reworked the original design by FedorSosnin on this site. I printed these models, but when I decided to assemble them, I ran into a major issue - it was extremely hard to do so. Therefore, I created a remixed T-nut based on DaVinci2000's model here because I knew it would fit perfectly and allow for sliding legs. Now they can easily slide on or off if you prefer to remove them. They are sturdy and well-made. If not, you will need to print two base feet per base. Also, I dislike having to take out supports from small areas, so the base has been designed in two different ways. One is split and doesn't require any supports, while the other is whole and does require some supports. This is my first remix, so any feedback would be greatly appreciated.