Ender-2 CR-10 5015 Cooler

prusaprinters

<p>I wanted a 5015 blower part cooler that didn't restrict my view of the extrusion and gave easy access to both bowden connector, and nozzle, without needing to unmount it. Not a common thing apparently so I made this. Designed for the Ender-2 but will also fit CR-10. I ran it for 4 days solid with no problems, good part cooling and stringing control. Its ridged and weighs in at 37g (2 shells, 3 top/bottom) printed at 0.2mm. Uses existing mounting bolts for carriage and 40mm fan. Blower needs 20mm bolt and nut to secure. Has a slot for clamping hot-end wiring to shroud (zip tie).</p> <p>Not a pretty design but it doesn't act like an air-paddle as it zips along the x-axis, and the entire cooler clears bed clips :)<br/> Print carriage-side down to the bed. Use split supports inside the manifold for easier removal. Don't add supports inside the blower air channel.</p> <h3>Print instructions</h3><h3>Category: 3D Printer Parts Summary</h3> <p>I wanted a 5015 blower part cooler that didn't restrict my view of the extrusion and gave easy access to both bowden connector, and nozzle, without needing to unmount it. Not a common thing apparently so I made this. Designed for the Ender-2 but should also fit CR-10. I ran it for 4 days solid with no problems, good part cooling and stringing control. Its ridged and weighs in at 37g (2 shells, 3 top/bottom) printed at 0.2mm. Uses existing mounting bolts for carriage and 40mm fan. Blower needs 20mm bolt and nut to secure. Has slot for clamping hot-end wiring to shroud (zip tie).</p> <p>Not a pretty design but it doesn't act like an air-paddle as it zips along the x-axis, and the entire cooler clears bed clips :)<br/> Print carriage-side down to the bed. Use split supports inside the manifold for easier removal.</p> <h3> Print Settings</h3> <p><strong>Printer Brand:</strong> Creality</p> <p><strong>Printer:</strong> Any</p> <p><strong>Rafts:</strong> No</p> <p><strong>Supports:</strong> Yes</p> <p><strong>Resolution:</strong> 0.2mm</p> <p><strong>Infill:</strong> 20% fast honeycomb</p> <p><strong>Notes:</strong></p> <p>Don't add supports inside the blower air channel. Will be very difficult to remove and prints fine without them.</p>