Ender 2 Bed Strain Reliever

thingiverse

After printing a few strain reliever designs from the community, I discovered that all of them crashed into the Y-axis motor. To overcome this issue, I designed the holder to support the cable from above instead of below, allowing it to clear the motor even when equipped with a damper. The design features two slots for zip-ties to secure the cable and also supports the holder itself via two out of three bed springs. I had to make some adjustments to one of the belt ends on the bed as it collided with the holder when fully extended. I simply loosened the Y-axis and bent the crimped end forward, which resolved the issue without compromising the belt's tension. Attached is the .blend file I created for this design.