Ender 2 Bed Leveling Knob

thingiverse

I opted to create new bed leveling knobs from scratch after yesterday printing a batch and discovering none of them fit the far adjustment knob properly. This final design was my eighth iteration, following six prints before settling on what worked perfectly and then adjusting for maximum size to fit snugly - on the back adjustment knob. A considerable amount of work went into this design, even though it's quite basic - so I hope you find some use in it! It turned out to be more complicated than initially thought, but the final print works flawlessly and I plan to replace all three of my adjustment knobs with this design. Note: To assemble the design correctly, flip it over so that the flat cutout is on the bottom. Then, simply remove the knob entirely and slot it into place within the print.