Ender 2/3/5 BMG direct drive mount

thingiverse

Works on Ender 2 as well, just purchased one recently. I'm not entirely certain about Ender 3 compatibility but assume they're essentially the same machine. ________________________________________________________ June 12 2019 Update - Successfully tested with "3D touch". ender_5_direct_drive_v1a_BLtouchV3_fix.stl ________________________________________________________ June 10 2019 Update - Added untested BLtouch V3 version. ________________________________________________________ June 7 2019 Update - Included untested BLtouch mount, based on salcatroppa's design from thingiverse: https://www.thingiverse.com/thing:3383611 ender_5_direct_drive_v1a_BLtouch_fix.stl ________________________________________________________ June 6 2019 Update - A more compact v1a version. ________________________________________________________ Ender 5 BMG direct drive mount utilizing the stock motor. ** Requires a longer M3x8 screw for the smaller hole. ** Needs replacement of the stock stepper motor wire with an extended XH2.54 4-pin to 6-pin cable, approximately 100cm long. ** Swap the two middle pins at the 6-pin end of the connector. ** Prepare a short PTFE tube (about 5cm) between the extruder and hotend.