Ender 2 3 4 5 CR-10 20 X & Co Single Fan Dual Hotend Lightweight Build

thingiverse

I'm testing a 2 MK8 setup with an 80mm fan to keep everything running smoothly and at the right temperature. I've taken water test footage from one of my old builds, but I've kept the fan in the same position so the results should be consistent. Here's what happened: for the first 15 seconds, the fan was blowing at full speed, and then it slowed down to 40% towards the end. I'm also running a bridge test from another old build, keeping the fan in the same spot to ensure accurate results. You can check out the water test video here: https://www.youtube.com/watch?v=q_TnagxycB0 And here's the bridge test video: https://www.youtube.com/watch?v=7btCyyi_Zx4 If you're interested, I've also shared my design for this setup on Thingiverse: https://www.thingiverse.com/thing:3347669