Endcap 1515 Misumi Extrusion

thingiverse

The prints were made using Misumi Aluminum Extrusion Endcaps in a 15x15 configuration. One print was created with an extruder temperature of 0.1 and a nozzle size of 0.4, while the infill density was set to 100%. The resulting fit was perfect, indicating that this combination of settings works well for these endcaps. Another print used the same nozzle size but increased the extruder temperature to 0.2, with an infill density of just 50%. Despite this reduced infill density, the fit was still good, showing that this setting can also produce satisfactory results. The third print pushed the extruder temperature even higher, up to 0.35, while decreasing the infill density to a mere 20%. Once again, the resulting fit was good, demonstrating that these endcaps are capable of accommodating a wide range of printing settings and conditions.