End Stop test for Prusa MK2.5S

End Stop test for Prusa MK2.5S

prusaprinters

Test STL to check if we gain 2mm with a different endstop.== Update ==I did gain 2mm back from my MK2.5s after using this changed part, but you have to do a xyz calibration after fitting the part. It's still 2.4mm off the start for me, but much better than the 4.4mm I had before.Also make sure the wire harness on the back isn't pinched when homed, you might need to rework the wiring to make it thinner.I will try to gain another 1mm by reworking my wiring, I don't think I can get the final 2.5mm that I'm missing just from this change. So I'll probably try to adjust the two bolts on the bottom and see if there's margin to move the bed another 1.5mm.== Update 2 ==I've included more sizes, I'm printing all of them today and testing how far I can go, the 7.5mm one would eliminate the problem for me IF there's enough room to still trigger the switch.Please don't try these smaller sizes unless you reworked your wire bundle on the back to make sure you have enough space, otherwise the wires might get mangled.== Update 3 ==Tried the 8mm first it didn't activate the switch at all, so I went with the 9mm one, only gained another 1mm, but that's 3mm from the start, looking at the x carriage looks like there's a bit more space, so I produced a 8.5mm part going to try that now.Looks like anything under 8mm is going to be useless, so even if the 8.5mm works I still need to find another mm somewhere.== Update 4 ==Ok, the 8.5mm worked on my printer my minimum offset is now 0.99m from the edge a good improvement from 4.5mm that I had before, but still not perfect.I will try now to move the bed 1mm the other way to close the final gap. I'll update this description once I've tried moving the bed.

Download Model from prusaprinters

With this file you will be able to print End Stop test for Prusa MK2.5S with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on End Stop test for Prusa MK2.5S.