end stop bracket for CR10S

thingiverse

I created these custom brackets to resolve a persistent rattling noise issue with my printer's operation. Upon investigation, I discovered that the source of the noise was metal brackets attached to end stop switches. To address this problem, I used Fusion 360 to design new, smaller brackets specifically for the X and Z axes. The Z-axis bracket is slightly thinner at 2 mm. By removing metal from one end switch and allowing a roller to contact the switch instead, my printer's noise has been significantly reduced. Even with stepper dampeners installed prior to this modification, some rattling remained; however, it is now almost completely eliminated. I hope this solution proves useful for others facing similar issues; please feel free to reach out with any questions or concerns.