End Frames for Condenser Coil Brackets: 2gal bucket + copper tube condenser(moonshine/sanitizer)

thingiverse

Human: Build a Frame for a 2 Gal Bucket Condenser Coil(moonshine/sanitizer) Items you will need to build the condenser: 3D Printer 2 gallon hdpe bucket(approx 20cm diameter at bottom) 1/4" od copper tubing(~20ft), perforated/slotted angle brackets: 1.5inx1.5inx2ft(cut into 3x8" segments) various brass fittings + npt nuts(to create bulkheads and an to connect to the boiler *possibly substitute rubber hose with clamps for much of this*) Print both top and bottom(reflection) parts, then secure with zip-ties. First try, angle brackets were at a bad angle, so I had to use zip-ties to attach the coil. The "fix" file should require fewer zip-ties to assemble. Related Reddit post: https://www.reddit.com/r/firewater/comments/g2oupc/hand_sanitizer_homebrewfermenting_stillexperiment/ And Imgur post: https://imgur.com/a/fkLIaZa Note: Use very low heat, and go slow. It might also be good to look into DIY cardboard+ptfe gaskets. Additionally, 1/4"OD tubing generates a lot of back pressure, so it's probably better to use bigger tubing (which is stiffer). Have a lot of ice cubes ready, and get a license (especially if the intention is to drink).