Enclosure-Ventialtion

thingiverse

I designed a custom Fan-Mount for my enclosure because the temperature was getting too hot (for PLA) when the doors were closed. This design is optimized for a 120mm filter and a 5mm activated-carbon filter. I used an ARCTIC P12 - 120 mm fan, but you can probably use any other 120mm fan without guarantee. The printer must be well-calibrated to print this design correctly, as it may need to be printed slightly larger than the original size to fit properly inside the fan. To assemble the mount, you'll need the following items: * 4x M4 screws (mine were 50mm long) and nuts You can use any other 120mm fan in place of the ARCTIC P12 - 120 mm, but there's no guarantee it will work correctly. To attach the fan to the mount, insert the nuts into the corresponding holes on the back, then drill a hole in your enclosure wall where you want the fan to be. Also, drill four 4mm holes for the screws that need to pass through the wall, making sure there's enough material around each hole for stability. There's an extra hole in the front of the mount for passing through the fan cable. If you have any questions or concerns, please feel free to ask in the comment section.