emoji sad cam cover

pinshape

Emoji Cam Cover Not the most straightforward print, but designed to be printed in sections and assembled as an inlay print. This one was printed on a Creality with a 0.35mm nozzle and 0.2 layer height using PLA filament from Ctrl Design off the shelf. Nozzle temperature is set at 210 degrees Celsius, while bed temperature is maintained at 62 degrees Celsius. Make sure all parts are centered in your slicer before printing. Step 1: Print only the parts of the emoji you want to use, excluding the yellow or red components. Step 2: Print the sad yellow part 1 and stay with the printer to turn on the heated bed when it's done. Don't remove the print from the bed; instead, place the other emoji parts into it. Step 3: This is the tricky part. Ensure that the file for sad part 2 is placed 1mm above Z0, then run it through your slicer and verify if it's 1mm higher than the bed level 0. If you do this correctly, you can start printing, and it will print over the existing inlay parts on your bed. Step 4: Measure the thickness of your device and print the right comb clip file accordingly. Good luck with the print.