emoji cam cover

cults3d

emoji cam cover This is a design for the design contest computerparts on my mini factory Not the most simple print but designed to print in parts and then print as an inlay print. this is printed on a creality with a .35 nozzle and layer height 0.2 with pla filament off the label by ctrl design nozzle temp is 210 and bed temp is 62 Please make sure that al the prints are centered in your clicer. step 1 print the parts of the emoji of your choice except the yellow or red parts. step 2 print the smile yellow part 1, sad yellow part 1, or devil red part 1 stay with the printer so you can turn back on the heated bed when the print is done. do not remove the print from the bed but take the other parts of the emoji and place them in the print. step 3 this is the tricky part. Make sure that you place this file (devil part2, smile part2, sad part2) 1mm above the z 0. then run it trough the clicer and check if its 1 mm higher than the bed level 0. If you do not do this the nozzle will destroy the print. If you do this right you can now start the print and it will go over the print witch is still on your bed with all the inlay parts. step 4 measure the thickness of your device and then print the right comb clip file. good luck printing this is a design you can print but not sell copyright is with by ctrl design