EMLID RS+ / RS2 Power supply + Modem 433Mhz

cults3d

Small module for installing 4 18650 batteries in series to power Emlid RS+ and RS2 GNSS antennas. To make the assembly, 2 5mm LEDs, 2 resistors, 1 holybro modem, some m2 and m3 screws, as well as cable and the 4 batteries will be needed. Emlid cable is also required. I've added a switch to turn the battery power on and off. This little box can be used to transmit corrections and the position of the base via 433mhz frequencies or any other frequencies available on holybro modems. Batteries also extend antenna life. Small module allowing the installation of 4 18650 batteries in series, to power the Emlid RS+ and RS2 GNSS antennas. In order to do the assembly, 2 x 5mm LEDs, 2 resistors, 1 holybro modem, some m2 and m3 screws, as well as some cable and the 4 batteries will be needed. The Emlid cable will also be necessary. I added a switch to turn on or off the power supply from the batteries. This small box allows to transmit the corrections and the position of the base by the 433mhz frequencies or all other frequencies available on the holybro modem. The batteries also allow to extend the lifetime of the antennas. Translated with www.DeepL.com/Translator (free version)