eMAKER Huxley Power Socket Holder

thingiverse

My acquired Huxley came with a socket for plugging in the power supply, which is more convenient than direct wiring. However, I was concerned about potential short circuits due to lack of space for the socket. To address this issue, I designed a holder that attaches to the rod on the right-hand Z Axis bracket. I may enhance it later by extending plastic around the rear of the socket to protect exposed wires and add a switch option. Print out the instructions and follow these steps: clean the larger hole if necessary, attach the power socket, remove the rear right-hand nut from the Z Axis motor support, slot on the holder, and reattach the nut.