Elongated Camera Mount w/Support Leg

prusaprinters

<p>This is nothing more than a remix of <a href="https://www.prusaprinters.org/prints/34705-elongated-snap-on-mk3mk3s-camera-mount-for-the-log">@</a><a href="https://www.printables.com/social/28313-dereksrose/about">dereksrose</a>'s fine <a href="https://www.printables.com/prints/34705-elongated-snap-on-mk3mk3s-camera-mount-for-the-log">Camera Mount</a> remix - except with an added support leg! &nbsp;The added support leg not only puts less stress on the extended arm but also prevents the camera from wobbling as the printer is printing.</p><p>This was originally designed for the Logitech C920/922 Camera but theoretically ANY camera with a screw in base should work. &nbsp;For those who may be interested, the Logitech takes a ¼"-20 screw so you can use that as your baseline. &nbsp;Ideally, the screw should probably be a ½" in length but as you can see above mine was a bit longer (about ¾" length) so I had to add some extra washers as “spacers” to secure it properly.</p><p><strong>NOTE #1:</strong> &nbsp;You do not need any supports if you're using the .3mf file in your slicer.</p><p><strong>NOTE #2:&nbsp;</strong> I did add a small piece of double-sided tape on the inside of the top clamp where it meets the top of the Y-Axis brace. &nbsp;Without it, the snaps were just a tad too high and there was some play when it was snapped on. &nbsp;By adding the 1mm thick tape that was just enough to sturdily secure it. &nbsp; In the picture above, you can see the white tape where the support meets the top of the Y-Axis to see what I'm talking about.</p>