Elko dimmer

prusaprinters

A knob with a flat surface instead of curved, it is also thicker so that the insides do not show through the surface. As well as an extended connector that touches the bed while printing for better results.The tightener that comes with the original part, as shown in the pictures (or something similar) is recommended to ensure a tight fit.Print NotesPrint with flat side up with normal supports and ironing enabled for a nicer visible surface. Be careful not to break the middle parts when removing supports.Higher resolution/lower layer height and speed are recommended.The "tree" support type is NOT recommended for this print. Print SettingsRafts/Brim:No, maybe if not using glueSupports:Yes, normalInfill:Higher is betterFilament:PLA