Element RC Trailrunner (Fender Kit)

cults3d

This is a DIY 3D Printable kit to close off the underside of your Trailrunner. The fenders are designed for the stock Trailrunner configuration. They can be used with the other Enduro body’s but may require some trimming on the overall width depending on the body. I did print and install the Knight Customs printable parts on the shell before I started designing just to make sure that what I do is compatible with what they already did. The designs will compliment each other and should folks want to use both there will not be fitment issues. The rear bumper delete slips nicely under the rear tail velcro mount. We can now remove the rear ladder body mount to clean up the overall look of the interior. Front and rear have caps that bolt to the sliders that are removable should you move on to an aftermarket slider or no slider at all. FRONT: Left/Right Fenders, Joiner cap, Incognito Mount Front REAR: Left/Right Rear Fender, Bed Cap, Fore Fenders(Fill the gap from the fender to the Running board, Split Tail Cap/Tail Cap with velcro body mounting option, Incognito Mount Rear The rear tail cap has a lip that follows the bumper line on the body that will allow you to attach the body in the rear with a strip of velcro and remove the tall body mount. The top of the mount rests on that curve and shouldn't sink down over time. The tight clearance of the rear fenders will keep the body from shifting left/right. The front will go to a clip free mount using the incognitos I designed. It should help further clean up the look of the shell.