Elegoo Saturn Trippy Drippy Bracket W/ Longshanks Edition

thingiverse

And because I just can't leave well enough alone, here's Trippy Drippy MKV. This is the latest version of https://www.thingiverse.com/thing:4912424 My Elegoo Mars 2 Pro came with a bracket that held the printing plate at an angle to allow resin to drip from the plate back into the vat after a print was finished. My Elegoo Saturn did not. So, I made one. Plus I canted it so that the right rear corner is the lowest point. This version kicks back to allow the printer housing to be put back on while the resin drips. MKV is the original, MKVI is extended. *UPDATE: After printing a large model (maxed out the build area) some of it was hanging over the edge of the vat. So I made the "Longshanks" Version, its deeper to accommodate "most" prints, and at a lesser angle.