Elegoo mars pro ventilation duct

thingiverse

This model is made to snap on to the existing Elegoo mars pro side paneling without needing any glue or magnets. All the other versions I've seen require you to open it up, and some even need you to drill holes into the metal case, which is a hassle and makes it harder to move around if needed. to improve effectiveness you can use sticky foam on the edges of the holes that mate with the printers vents to keep it more air tight, as well as cap off the fan slot "features" -fan slot, (should) accept any 120mm PC fan -adapter allows for the mounting of a 4" diameter HVAC tube, ideally the flexible type for versatility -easy installation -non permanent attachment to the elegoo mars pro -support material optimized design -access port to power switch and plug (that's why the fan is raised)\ -takes about 400 grams to print both parts please note that the adapter needs to be super glued or "plastic welded" to the main mount (could have included a removable mounting bracket but that would take too long and make it harder to print)