Elegant Wine Rack

prusaprinters

<p>This wine rack is designed to hold ordinary and the somewhat wider (usually red wine, 86mm) bottles but not the super fat champagne/prosecco style bottles.&nbsp; The units are infinitely stackable so you can make a 3, 6, 10 or even taller bottle rack.&nbsp; For a six-bottle rack you’ll need to print two lefts, two rights, a centre and a top.</p><p>The bottom slot that connects the lower units together has a 0.1mm tolerance. &nbsp;Depending on the accuracy of your printer and what type of filament you use, that may be either too tight or too loose. &nbsp;If too tight, obviously, you'll need to do some sanding. &nbsp;If it's loose, add some thin two-sided tape or a blob of glue between the units and/or on the support connectors. &nbsp;As they are supporting wine bottles, you'll want to be sure they're well fitted and secure.&nbsp; When fitting together, lay the units on their backs so they align perfectly.</p><p>I printed mine using eSun (sorry Joe) Gloss Silky PLA, 2.5mm layers, 2 perimeters, 10% infill, and Seam Position: Rear so the seam will be on the bottom of the unit and won't be visible. &nbsp;Also, I tend to use thicker extrusions (0.55mm). &nbsp;If you use the standard 0.45mm you might want to go with 3 perimeters to add strength and so the infill anchors don't show through.</p>