Elegant bag clip, very strong, various sizes

thingiverse

I know there are a lot of nice bag clips here already, but I wasn't entirely happy with any of them, so I added another design. There are 3 sizes for clamping lengths of 65 mm, 90 mm and 120 mm.My design goals were:stability,longevity,high holding power,easy operation,no notoriously weak hinges,easy printing,and last but not least a pleasant appearance.How to use:As a rule, it is enough to bend the clip on the closure by a maximum of 1 cm in order to slide a bag between them or to remove a bag. It is not intended to bend the clip to larger angles. Bending too hard can cause the clip to break.To open a locked clip, please use one of the two methods shown here:https://youtu.be/p4mRMj1A3TUPrint settings:First of all - a flexible material must be used, such as PETG. I haven't even tried printing clips with PLA since I don't think they will work for long (PLA permanently deforms under tension).I also recommend:line width 0.4 mm,layer height 0.2 mm,3 wall lines,4 floor and ceiling layers each,25% zigzag infill.a z-seam positioned as in the print preview above.