Electronics Enclosure

thingiverse

Designed this to go with my own REPRAP version of a tevo tarantula. Internals are designed to hold a ramps 1.4 board/ arduino mega alongside a external mosfet for the heated bed. Due to the constraints of the size of the bed, the design has been split into 8 quadrants instead of just 4. The HD brackets were first extended to allow all the electronics to be nested below before the enclosure was then designed around this. I have gone over the top of fan mounts as the current mosfets and drivers on my board run hot however the plan is to fill half of these filled in with simple fan caps. Any advice would be highly appreciated as I am very new to 3D printing!