Electronics Control box

thingiverse

Here's a simple electronics control box enclosure I built for one of my projects that you can check out on Thingiverse at http://www.thingiverse.com/thing:1240527. This design centers around a 45x45mm perfboard from RadioShack, which is the key component in this case. Although it might work with other boards, I'm not sure - ultimately it comes down to whether their hole patterns will match up correctly for the posts. After recording a video for it, I modified the post design to make them slightly tapered, hoping that would help prevent the hassle of having to widen the holes on the board. Since then is exactly what had to be done in my own case! I intentionally made the gasket thicker than the gap allowed for to increase clamping pressure, which should do the trick nicely with a ninja flex printout to get the best fit. In reality though, I think this could likely get by without being made altogether.